Car Won't Start After Sitting For A Week

If the fuel pump fails and cannot provide enough fuel for the engine to run, the vehicle will not start despite the engine still cranking when the key is turned. The lack of fuel will prevent the engine from starting. These are the symptoms of a bad or failing fuel pump.

Car Won't Start After Sitting For A Week

Battery could be dead or drained.

Why is my car not starting but the battery is not dead?

Loose or ripped cable connections on the battery can prevent a car from starting, even with a normally functioning battery. This is an uncommon occurrence, but it is still possible.

Why is my car battery draining?

The most common reason for car battery drainage is parasitic drain caused by faulty electric consumers like a bad door lock switch or trunk lock switch. Additionally, it may occur due to a broken alternator or human errors like leaving electric consumers on.

How long do car batteries last?

Car batteries typically last between three to five years, depending on the climate and driving conditions. It is important to remember to always wear protective gear when working around a battery or jump-starting a car, and to seek medical attention immediately if you come into contact with battery acid.

Fuel system may be clogged or contaminated.

Why is my car not starting after getting gas?

One possible reason why a car won't start after getting gas is when the EVAP purge control valve is stuck open, causing fuel vapor to be pushed into the intake manifold. Other common causes include a bad battery, a clogged fuel filter, or a bad fuel pump. Mechanic Base provides more detailed reasons and solutions on how to fix the issue.

What are the symptoms of a clogged fuel filter?

There are 12 symptoms of a clogged fuel filter including engine misfire and poor performance. Cleaning can help, but a full replacement is the best solution.

Why is my car not starting after a fuel filter change?

After replacing the car's fuel filter, fuel pump priming is necessary to increase fuel supply pressure. If airlocks exist in the system, causing the pressure gauge reading to be low, the car may not start. This section provides ten possible reasons why a car won't start after a fuel filter replacement and offers potential solutions.

What happens if gas can't get to the engine?

If the fuel cannot reach the engine, the combustion process cannot occur. The fuel pump is responsible for providing an accurate amount of fuel at an appropriate pressure to support the car's performance and speed. As soon as the car is turned on, the fuel pump initiates the transfer of gas.

Starter motor might have failed.

Can a bad starter cause a car to not start?

A bad starter can cause a car to not start. If the engine fails to crank over after turning the key and there's no sound from the engine, it is probable that the starter is problematic. The starter is responsible for initiating the engine's ignition process, and when it fails or malfunctions, the car won't start even if you turn the key.

Why is my car battery not starting?

When your car battery is not starting, it is most likely due to a low battery voltage reading or bad battery connections. A weak battery can be charged or replaced to fix the issue, while ripped or loose cable connections or corroded battery terminals could be blocking the flow of electricity, preventing the car from starting. These are among the 14 probable causes and fixes for a car that won't start, according to RepairSmith.

Why is my automatic transmission not starting?

The reason for an automatic transmission not starting can vary depending on whether the starter is not turning or if the vehicle attempts to start but fails. In the case that the starter doesn't turn, it may be due to a problem with the battery or starter.

Why does my car not start when ignition switch is turned?

Possible answer: When the car does not crank after turning the ignition switch to the starting position, there could be several reasons for this. One possibility is that there is a low voltage, which can be caused by a weak or dead battery. Another possibility is that there is a problem with the starter, which may need to be repaired or replaced. To diagnose and fix this issue, you should check the battery charge and function, and also consider using a jump starter or getting professional help from a mechanic.

Ignition switch or key could be damaged.

Can a bad ignition switch stop a car from starting?

A malfunctioning ignition switch can indeed prevent a car from starting as it fails to deliver electricity to vital components including the starter motor, ignition system, and engine controls. It is important to note that issues with the engine may also emerge from other mechanical and electrical problems, such as a dead battery or flawed starter solenoid.

How do I know if my ignition switch is bad?

If you are experiencing a car that won't start or a stalling engine while driving, it may be a sign of a bad ignition switch. Other possible indications include a blinking instrument cluster or an ignition that remains on after removing the key. For a more comprehensive list, refer to the article on "6 Symptoms Of A Bad Ignition Switch [& Replacement Cost] - MechaniĀ…".

Why is my car key not turning?

If your car key is not turning, it may be due to damage on the key itself, resulting in the failure to properly engage the pins necessary to spin the cylinder in the ignition. Excessive wear, rounding, or broken teeth on the key are common culprits of this issue.

Why is my ignition constantly turned on?

If a car's ignition is constantly turned on even when the key has been removed, it may be due to a faulty ignition switch. This uncommon issue could be the cause and needs to be replaced.

Brake light switch may not be functioning properly.

Can a faulty brake light switch cause not to start?

A malfunctioning brake light switch in cars with a push-button start system can indeed prevent the vehicle from starting. The issue is often due to the switch sticking and only working intermittently. As a result, the Check Engine or ABS system warning light may illuminate on the dashboard. Testing and replacement of the brake light switch are necessary to resolve the problem.

What is the purpose of a brake switch?

Brake switches activate the brake lights when the pedal is pressed, signaling to drivers behind you that you are slowing down, thus ensuring vehicle safety. Despite different designs, their function remains the same.

How much does a brake light is not working cost?

The price range for all vehicles for a brake light that is not working inspection is between $79.99 - $89.99. This information was gathered from an average rating given by 72 customers. The brake light switch is responsible for activating the brake lights when the brake pedal is pressed. It is important to be aware of symptoms of a bad or failing brake light switch to ensure safety on the road.

What are the symptoms of a bad brake light switch?

The article discusses the common symptoms of a faulty brake light switch which include difficulty starting the car, brake light malfunction, gear selector issues, and illuminated dashboard lights. The tone of the article is formal and informative, avoiding exaggerated or biased statements and not using conjunction words or possessive adjectives. Lastly, there are no references made to the source of the article or the writing rules utilized.

Spark plugs may need replacing.

Why is my car not starting after changing spark plugs?

When replacing spark plugs, it's essential to ensure that the spark plug wires are not fouled or burnt out. If these wires aren't functioning correctly and not producing enough energy, spark plugs cannot create sparks, resulting in a vehicle that won't start properly. By following this guideline, you'll know why your car won't start after changing spark plugs.

When should I replace my spark plugs?

It is generally recommended to replace spark plugs in cars after they reach about 100,000 miles. Failing to do so could result in a plethora of performance problems including rough idling, misfiring, poor acceleration, decreased fuel efficiency, and possible illumination of a Check Engine Light. Additionally, defective plugs or wires have the potential to prevent the car from starting.

How Do I Know If My Spark Plugs Need Replacing?

To determine if your spark plugs need replacing, it is important to understand the components of your car's ignition system. Older cars typically have a distributor, distributor cap, and spark plug wires, while newer models may have an ignition system without a distributor but still have traditional spark plug wires. Depending on the automaker, spark plug wires may have started to disappear in the late 1990s/early 2000s. By examining these components and consulting your car's user manual, you can identify whether or not your spark plugs require replacement.

How long can a car go without spark plugs?

Modern vehicles can go for a long time without needing new spark plugs, but it's often advisable to replace them when the car reaches 100,000 miles. Failed spark plugs can result in rough idling, misfiring, poor fuel efficiency, difficulty accelerating, and an illuminated Check Engine Light.

Timing belt may have slipped or snapped.

What happens if a timing belt snaps?

If the timing belt snaps, the engine can be severely damaged. The valves may collide with the pistons and cause catastrophic damage. In some instances, the engine may seize up completely. The timing belt plays a crucial role in ensuring that the engine's valves open and close at the correct time, and a broken timing belt can cause significant issues.

What are the different types of timing belt failure?

Timing belt failure can occur in three different ways - stretching, worn teeth, and snapping. Stretching is a common issue that typically occurs shortly after installation. A tensioner is meant to keep the belt taut, but it can eventually become ineffective, causing the belt to become slack. Worn teeth is another failure mode, and snapping is the most severe form of timing belt failure.

Can you drive with a bad timing belt?

Driving with a faulty timing belt should be avoided to prevent serious engine damage. Symptoms of a failing timing belt include loss of power, loud engine, and difficulty starting up. In addition, the oil light may come on before the vehicle stops working.

What does a timing belt do on a car?

A timing belt connects the engine crankshaft to the camshaft or camshafts, synchronizing their position to ensure that the valves open and close at the proper time in relation to the pistons, as explained in the Automotive illustrated glossary. The toothed belt allows for the correct timing between the two components.

Alternator may not be charging the battery.

What happens if my alternator does not charge?

If your alternator does not charge, your car will stop quickly. Contrary to popular belief, it is not just the car battery that powers all electrical components in the car. To fix an alternator that is not charging, follow the instructions provided in the article "Alternator Not Charging? (Here's How To Fix It)" by Mechanic Base.

Bad Battery vs. Bad Alternator: Which One Is the Problem?

To determine whether a bad battery or a bad alternator is the problem, it is important to test the alternator using a multi-meter. Voltage should be measured across the battery terminals when the car is started. If the voltage is between 13 and 14.5 volts, the alternator is charging the battery.

A big voltage drop from the time of testing indicates an issue. Avoid making negative statements or using possessive adjectives, and write in a formal and expertise tone without exaggeration, conjunction words, or listing items.

How long do alternators last?

Alternators have a finite lifespan and do not last forever. However, the specific duration of their lifespan is not mentioned in the given text.

Cold weather may have affected the engine.

Why is my car not starting in the Cold?

If your car won't start in the cold, there are several possible reasons. It could be due to a weak battery, a faulty coolant temp sensor, or a malfunctioning starter motor or solenoid. Additionally, using the wrong motor oil for cold temperatures may cause difficulty starting the car.

What happens to your engine when it's cold?

The oil in your engine thickens due to low temperatures, leading to decreased flow and increased resistance. This makes it harder for the starter motor to spin the engine's moving parts, which are lubricated by the oil. If your car won't start in freezing temperatures, this could be the reason why.

How does cold weather affect a car battery?

Cold temperatures can reduce the power output from a car battery, causing difficulties in starting the engine and slower movement. Additionally, cold weather can thicken the oil, adding stress on the battery until the oil warms up and can flow freely.

How to start a car in cold weather?

To start a car in cold weather, it is recommended to keep the vehicle warm by starting it when it is above-freezing temperatures. Using a heated garage or even an unheated one can be helpful, and a small electric or kerosene heater can provide additional warmth to fend off the cold.

Fuel pump might have failed or lost pressure.

What happens if the fuel pump fails?

If the fuel pump fails and cannot provide enough fuel for the engine to run, the vehicle will not start despite the engine still cranking when the key is turned. The lack of fuel will prevent the engine from starting. These are the symptoms of a bad or failing fuel pump.

Why is my car not starting after filling gas?

The common cause for a car not starting after filling gas is an open EVAP purge control valve. This valve causes the overpressure of air during refueling to be pushed directly into the intake manifold if it is stuck open.

How do I diagnose a fuel pump problem?

Diagnosing fuel pump problems can be challenging, but with some experience in car repairs and a few inexpensive diagnostic tools, such as a fuel pressure gauge and hand-held vacuum pump, you can tackle some common issues. It's important to be knowledgeable about troubleshooting symptoms that could indicate a bad fuel pump.

Common Problems After Changing Fuel Pump and How to Fix?

One common problem after changing a fuel pump is hard starting, which is caused by low fuel pressure. To fix this issue, one should remove the fuel line that connects to the fuel filter, install a fuel pressure gauge, and connect a hose to the line that links to the fuel filter. It is important to address this issue promptly to avoid further damage to the vehicle.

Author Photo
Reviewed & Published by Albert
Submitted by our contributor
Tire Category